The Next Steps In Installing Home Alarm System

Try to partially unscrew the two screws on the receiver plate using a screwdriver. You have to wind the exposed end of one of the two wires around one of the two screws. This procedure will be repeated with the exposed end of the other wire and the other screw. Security Systems and Alarm Belmont the next thing will be making the cable run down the wall until you come to the baseboard and then run the cable along the baseboard of the wall until you come to where you plan to place the alarm control panel. For this, you have to staple the cable to the baseboard using a staple gun so that the wire will not be accidentally pulled out. Security Systems and Alarm Belmont You may place the alarm control panel on a table or in some other surface in an area that is the center to the house and it should be even next to a power outlet. Now, just turn the panel over and you can now remove the backup battery compartment lid. Just simple place batteries and close the lid and then plug the power cord of the panel into the outlet to turn it on then.